Skip to main content

eCalc v11.1

Features​

  • Results at consumer level (FUEL_CONSUMERS and CONSUMERS under GENERATOR_SET) will no longer overwrite results with the result from the previous timestep when results are invalid (ie. results from valid steps would extrapolate over invalid results). Instead, the actual result will be returned. This means that you can now safely trust the results, even when they are invalid, to better understand what is needed in order to make them valid. You may experience that the GENERATOR_SET will contain invalid points where it previously did not. This will be because the (invalid) power demand from a consumer with an invalid point is now reported/aggregated to the GENERATOR_SET. This invalid power demand may exceed the power demand extrapolated from the last time step, which was reported earlier. If the total power demand for a GENERATOR_SET goes above the maximum power it will fail to provide sufficient power, and therefore be reported as invalid. There should be no changes in valid/invalid time steps at asset level. NOTE: It is highly recommended to use Data Defined Output frequency when evaluating invalid data, as using a fixed frequency may make it difficult or impossible to understand invalid date.

Bug Fixes​

  • Import error when empty model item in YAML:

    When YAML model had empty item, it is parsed as None and fail in replacing names.

    MODELS:
      - # <- empty item
      - NAME: ...

    The replacing of names should work as intended, even with empty fields.

Breaking changes​

CLI​